Plastic crusher suddenly stopped when it was crushing the material, have you ever encountered a situation？ This situation is puzzling and also gets people caught off guard. What you need to do at this time is to find out in time to see what is the cause. This article analyzes the possible causes of the crusher shutdown.
Material blockage in the crushing chamber of plastic crusher
The blockage of material is one of the reasons for the sudden stop of the plastic crusher. At this time, the material needs to be cleared. In use, it is strictly forbidden for materials with large particle size distribution or high water content to enter the equipment. Feeding material should be maintained evenly to prevent overfeeding.
Plastic crusher’s v-belt is too loose
It is necessary to check whether the v-belt of the plastic crusher is the problem. If it is too loose and causes the crusher to stop, you need to adjust the tightness of the v-belt. If the v-belt has been used for a long time and lost its tightness, you need to remove and replace the v-belt.
Working voltage of plastic crusher is not suitable
If the working voltage of the production site is too low, it cannot keep the plastic crusher running normally and shut down. This is the time to choose the voltage that meets the requirements of the equipment. Note that let the professionals check the voltage so as not to cause injury to the personnel.
Plastic crusher’s internal parts fall off
If the plastic crusher has the sound of metal touching each other before stopping, it may be that the internal parts of the crushing cavity fall off causing the equipment to stop suddenly. This is the time to carry out the machine and equipment internal check.
Plastic crusher bearing clamping or spindle breakage
If it is caused by the spindle breakage, the worn spindle should be repaired or replaced. If it is caused by the bearing holding, find out the cause of the holding. To install the bearings correctly, make sure the bearings have a certain working clearance. Normally, you should do a good job of lubricating the plastic shredder bearings and maintain them regularly.
Problems with the connection line of the plastic crusher
The device can also stop suddenly if there is a broken or poorly contacted connection cable. Especially if there is no sound without warning, it is likely that the connection cable is faulty.
If the plastic shredder machine suddenly stops, we can go to the above-mentioned points to investigate the reasons for the sudden stoppage. We should strive to get the operation of the crusher machine back to normal as soon as possible to ensure the normal production of the plant.