The label remover is the equipment that removes the label from the PET bottle. The speed of de-labeling directly affects the productivity of the plastic bottle washing line as well as the daily output. This news analyzes the possible reasons that affect the working speed of the label remover.
Sieves of label remover
Under normal conditions, the width of the vibrating screen determines the handling capacity of the label remover screen. The wider the screen surface, the greater the handling capacity. The length of the screen decides the screening efficiency of the screen. The longer the screen surface, the higher the efficiency.
But for the vibrating screen to increase the width and length is usually limited by the structural strength of the screen frame. Excessive width and length not only do not improve the efficiency much but also make the life of the screen frame shorter. Sieve capacity and screening efficiency are two interdependent indicators that must be considered simultaneously. Usually, the screen length is considered after the screen width is determined.
These are the comparison picture of plastic bottles before and after relabeling. The left is the picture before relabeling, and the right is the picture after relabeling
Sieve plate angle of label remover
The screen box of the high-frequency dewatering screen should be installed with the horizontal plane lateral level, if the horizontal level of the screen box does not reach the balance will make the screen surface produce a certain degree of offset, and the material can not be straight flow.
The main part of the screen plate of the dewatering screen is 5° up in the horizontal direction, and the rear part of the high-frequency dewatering screen plate is at an angle of 45° with the main board.
Two balanced vibrating motors are mounted horizontally, one at the upper end of the other, and the slewing effect of unbalanced gravity during rotation makes the sieve work very steadily.
If there is a problem with the installation angle of the screen plate, the vibration strength will also be affected, thus causing the phenomenon of not walking material.
